Operating Instructions; Mode Control - TensCare Sports TENS 2 Mode D'emploi

11.2. OPERATING INSTRUCTIONS

ON/OFF
To turn the unit ON, press the
ON/OFF button and hold for 3 to 5 seconds until
the display shows.
To turn the unit OFF, press the ON/OFF button
on the top of the unit and hold for 3 to 5 seconds
until the display stops
The unit will turn OFF automatically:
When the Timer reaches zero,
If it is left at zero strength for more than 5
minutes.
The unit will start with the programme you used
last.
Note: Always check unit is OFF
before applying
electrode pads.
The backlight will turn off 10 seconds after the
last button press.

MODE CONTROL

for use on body areas with small, medium and
large muscles (see section 9.1.).
Note: The intensity must be reset to
zero before MODE can be changed,
otherwise PAUSE is activated.
or removing
MODE
Press the
button to select a
mode.
Display will cycle
through TENS, EMS
I, EMS II, EMS III
and MASSAGE (5
choices). Modes
EMS I, II, and III are
26
PROGRAMME CONTROL
The button marked P is the programme control.
The Sports TENS 2 has:
10 preset TENS
•
2 manual TENS
•
• 27 preset EMS (9 preset with 3 modes
each)
6 manual EMS (2 manual with 3 modes
•
each)
• 10 massage programmes
displayed.
Each time you change the programme, the
strength level reverts back to zero. This is a
safety feature to alleviate any sudden feeling of
a surge, as each programme gives a different
sensation.
STRENGTH CONTROLS
The buttons marked Ch1▲, Ch1▼, Ch2▲,
Ch2▼ are the strength controls.
The left-hand buttons
change strength in the
▲
left-hand lead, Ch1, and
the right-hand buttons
Ch1
change the right-hand
▼
lead, Ch2.
To increase strength in
steps of 1 mA, press and release
the top part of the channel buttons, Ch1▲ and
Ch2▲.
Each time you press
and release the P
button, the
programme changes
and is shown on the
LCD. The Hz and μs
settings for each
programme are also
▲
Ch2
▼