TensCare Sports TENS 2 Mode D'emploi page 28

The strength levels are shown on the LCD.
The strength control buttons will not
operate until the unit is properly connected
to you. If the Sports TENS 2 detects a
disconnection in either channel it will
automatically return the strength to zero in
that channel and flash '00'.
The unit has 99 levels of strength.
If you hold down the strength controls for 3 to 5
seconds, the strength will start increasing
continuously.
You may feel nothing over the first few presses.
Continue pressing until the sensation is strong
but comfortable. At each phase of the
programme the intensity automatically adjusts
to give a comfortable stimulation, however
further increases during use may be necessary
if your body becomes used to the sensation. To
decrease the strength, press and release the
lower part of the buttons marked Ch1▼ and
Ch2▼.
The yellow LED on the output socket indicates
that there is an active output which can be high
enough to be harmful if not used correctly. The
display will remain on for 5 seconds after the
plug is removed.
TREATMENT TIMER
The default setting for preset programmes is
shown. To alter the treatment timer setting see
section 11.
You can select any time between 1 and 90 or
continuous (marked as C).
LOW BATTERY
An empty battery symbol will show
when you need to charge the battery.
KEYPAD LOCK
If you do not press any keys for 10
seconds, the keypad will lock so that
only the keys marked Ch1▼ or Ch2▼ will work.
This is to avoid accidental changes in setting.
To unlock, press either Ch1▼ or Ch2▼ keys.
OPEN CIRCUIT CUTOUT
Note: The electrode pads need to be
applied directly to the skin before the
intensity
operate. If the Sports TENS 2 is not correctly
connected to your body, the strength in the
channel which is not properly connected will
automatically reset to zero. This is to prevent
sudden changes if a broken connection is re-
made.
PAUSE
Pressing the MODE button while a programme
is in use stops the stimulation and the timer.
The pause symbol is displayed on the screen
Press the MODE button again to resume the
programme.
MEMORY
To view the memory, press +MENU or -MENU
to cycle through parameters until MEM D is
displayed (to view the records on that date),
If no programme has been used for more than
19 minutes, 0 is displayed.
27
increase buttons will