General Specification - TensCare Sports TENS 2 Mode D'emploi

(Lead wires can break at the bend where they leave the machine giving no, or
intermittent, output).
Sudden change
If you disconnect and re-connect
in sensation a few minutes later, the signal will
feel quite a lot stronger.
If the above review has failed to resolve your problem, or to report unexpected operation or events, or to
provide feedback call TensCare or your local supplier or distributor (address on back cover) for advice.
Contact TensCare customer service on +44 (0) 1372 723 434. Our staff are trained to assist you with
most issues you may have experienced, without the need to send your product in for service.
European Medical Device Regulation requires that any serious incident that has occurred in relation to
this device should be reported to the manufacturer and the competent authority in your country. This can
be found at:
https://ec.europa.eu/docsroom/documents/36683/attachments/1/translations/en/renditions/pdf
19.

GENERAL SPECIFICATION

Waveform
Amplitude (over 1 kOhm load)
Output plug
Channels
Batteries
Weight
Dimensions
Safety Classification
Environmental specifications:
Always return strength to zero after
disconnecting the leads or electrode pads.
Asymmetrical rectangular bi-phasic
99 mA zero to peak +ve in 99 steps +/- 10%
Fully shielded: touch proof
Dual channel
Built-in lithium-ion battery
Model: WEL 703048 -900 MaH/3.7v
Manufacturer: We Action Electronics Co., Ltd
Ratings: 900 mAh, 3.33Wh, 3.7V
90g with belt clip
114 x 56 x 23 mm
Internal power source.
Designed for continuous use.
No special moisture protection.
34