General Specification - TensCare perfect TENS Mode D'emploi

18. GENERAL SPECIFICATION

Waveform
Amplitude
(over 500 Ohm load)
Output plug
Channels
Batteries
Weight
Dimensions
Safety Classification
Environmental specifications:
Operating:
Storage:
TYPE BF
EQUIPMENT
IP22
Note: The electrical specifications are nominal and subject to variation from
the listed values due to normal production tolerances of at least 5%.
Asymmetrical Bi-Phasic
60 mA zero to peak +ve in 60 steps.
+/- 10%
Fully shielded: touch proof
Dual channel
2 x AA alkaline (two AA batteries)
75 gms without batteries
120 x 60 x 20 mm
Internal power source.
Designed for continuous use.
No special moisture protection.
Temperature range: 5 to 40⁰C
Humidity: 15 to 93% RH non-condensing
Atmospheric pressure: 70 kPa to 106 kPa
Temperature range: -25 to +70⁰C
Humidity: Up to 93% RH non-condensing
Equipment providing a degree of protection against
electric shock, with isolated applied part.
This symbol on the unit means "Refer to Instructions for
use".
The unit is not water resistant, and should be protected
from liquids.
Complies with EU WEEE regulations
24