Setting Up And Using The Perfect Tens; Installation Of Batteries - TensCare perfect TENS Mode D'emploi

11. SETTING
USING THE PERFECT
TENS
11.1. INSTALLATION
BATTERIES
1) Remove belt clip by sliding down.
2) Remove battery cover by pulling on
tag.
3) Insert batteries.
Ensure that the batteries are inserted
the right way as shown in battery
compartment and that the ribbon is
behind them.
4) Replace battery cover and belt clip.
When the
running low, a low battery
indicator will show on the
screen and it is important to change the
batteries as soon as possible.
Rechargeable batteries
The unit will work with rechargeable
batteries, but the display may appear
dim.
UP AND
OF
batteries are
18
Storage
Remove batteries from your perfect
TENS if the unit is unlikely to be used
for a long period. Some types of
batteries may leak corrosive fluid.
Battery Life
Batteries should last about 48 hours at
full power.
Unused batteries have a nominal shelf
life of 3 years, but will usually last longer
than this.
Battery Warnings
Do NOT
disassemble, or use in a humid
and/or corrosive environment.
Do NOT
temperatures over 60°C(140F).
Do NOT
leave near sources of heat, in
direct strong sunlight, in a high
temperature location, in a pressurized
container or in a microwave oven.
Do NOT immerse in water or
sea water, or get wet.
Do NOT short-circuit.
Do NOT connect the device
unless the battery cover is in
place.
If battery leakage occurs and comes in
contact with the skin or eyes, wash
thoroughly with lots of water.
Keep batteries out of the reach of small
children.
pierce, open,
expose to
put, store or