Operating Instructions - TensCare perfect TENS Mode D'emploi

10.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit ON, press the
ON/OFF button on the top of the unit
and hold for 3 to 5 seconds until the
display shows.
To turn the unit OFF, press the ON/OFF
button on the top of the unit and hold for
3 to 5 seconds until the display stops
The unit will turn OFF automatically:
• When the Timer reaches zero,
• If it is left at zero strength for more
than 5 minutes.
The unit will start with the programme
you used last.
At first use, or after changing batteries,
the display shows that the unit is
automatically set in Programme A at
zero strength.
Note: Always check unit is
OFF before
removing electrode pads.
The backlight will turn off 10 seconds
after the last button press.
On the front of the unit there are six
buttons:
STRENGTH CONTROLS
The buttons marked CH1+, CH1-,
CH2+, CH2- are the strength controls.
The left-hand buttons
CH1+
change strength in the
left-hand lead, CH1,
and the
CH1-
buttons change the
right-hand lead, CH2.
applying or
CH2+
right-hand
CH2-
16
To increase strength in steps of 1 mA,
press and release the top part of the
two channel buttons, marked CH1+ and
CH2+.
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you. Perfect TENS
detects a disconnection
automatically returns the strength to
zero.
The unit has 60 levels of strength. If you
hold down the button for 3 to 5 seconds,
the strength will start scrolling.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable.
Further increases during use may be
necessary if your body becomes used
to the sensation.
To decrease the strength, press and
release the lower part of the buttons
marked CH1- and CH2-.
The yellow LED on the output socket
indicates that there is an active output.
The display will remain on for 5 seconds
after the plug is removed.
PROGRAMME CONTROL
The button marked P is the
P
programme
perfect TENS has eight different,
specially developed
lettered A to H, plus a manual
programme M. When the unit is first
switched on it automatically enters
programme A.
Each time you press and release the P
button, the programme changes and
the letter is shown on the LCD.
and
control. The
programmes