Programme Usage; Manual Programmes - TensCare Sports TENS 2 Mode D'emploi

7.2.

PROGRAMME USAGE

Massage programmes can be used to relieve
stiffness in the muscles. Simply experiment with
the different programmes to find the one that
you find the most relaxing.
Programme 1 alternates between two strong
squeezing/kneading feelings.
Programme 2 alternates between slow and fast
tapping.
Programme 3 alternates between gentle and
strong kneading.
Programme 4 has five steps of gradually
increasing strength of kneading, alternating
with tapping.
Programme 5 and 7 alternates between slow
and medium-strong tapping.
Programme 6 is a gentler form of programme
5.
Programme 8 is a pumping sensation at about
your own heart rate, that slowly increases in
speed over the course of the 20 min treatment.
It is especially effective with swollen legs and
veins.
Programme 9 is squeezing/kneading in 6 steps
of increasing intensity.
Programme 10 generates a tapping sensation
gradually speeding up, then slowing down.
8.

MANUAL PROGRAMMES

When a programme has manual settings
available, MANUAL will be displayed. The
manual programmes
programmes 11 and 12 as well as the EMS
programmes 10 and 11.
In the manual programmes, you can select and
change the following parameters:
are the TENS
Parameter
to Change
Frequency
Pulse Width
Treatment Timer (minutes)
DATE
HOUR
MEM D
MEM H
And for the EMS programmes only:
Work Time (seconds)
Rest Time (seconds)
1. Select the mode TENS or EMS using the
MODE button, then select one of the
manual programmes pressing P.
2. Press the +MENU to start changing the
parameters.
3. In the TENS programmes, you can change
the parameters frequency, pulse width,
treatment timer, date, hour, MEM D and
MEM H.
In the EMS programmes, you can change
the parameters: frequency, pulse width,
work time, rest time, treatment timer, date,
hour, MEM D and MEM H.
4. To adjust the parameter flashing on the
screen, use the + and – buttons.
5. To confirm your selection and go to the next
(or previous) parameter press +MENU or -
MENU.
6. Once the changes are complete, press the
return button
will stop.
See section 7 for more information on the
choice of settings.
17
Display Symbol
Flashes
Hz
μs
min
0 on the right
0 on the left
0 on the right
0 on the left
WORK sec
REST sec
to confirm. The flashing