Training Session - TensCare Unicare Mode D'emploi

Caution:
silicone-based lubricant on
the stimulation contacts as it
may decrease the effectiveness of
the Unicare's muscle stimulation.
3) Choose a comfortable position,
such as lying down on your bed
on your side with your knees
raised.
Warning: Ensure the Unicare
is switched
inserting the probe.
4) After the wire
connected, insert the probe into
your vagina, in the same way as
you would a tampon, until only
the plastic rim at the base of the
probe is visible.
5) The metal parts conduct the
electrical pulse and should be in
contact with the main part of the
muscle at all times. The tissues
close to the entrance are more
sensitive, so you should avoid
stimulating them.
Ensure that the probe is aligned so
that the contact plates are to the
sides and the longer sides of the
positioning end rim are vertical.
Do not use a
OFF before
is securely
Contact
plate
6) The Liberty Loop probe has a
pointer attachment
enables you to visually monitor
the successfulness of your pelvic
floor contractions (the probe can
be used without the pointer).
The pointer demonstrates the
strength and duration of each
contraction, whether caused by
stimulation
manually. For example, weak
contractions are defined by little
or no movement in the pointer.
Assemble the pointer and attach
to the probe as follows:
• When performed
correctly,
pointer will move
downwards.
• When performed
incorrectly,
pointer will move
upwards.

14.4. TRAINING SESSION

1) Press and hold the ON button on
the control unit for 3 to 5 seconds
to switch the control unit on.
29
Positioning
end rim
which
or performed
the
the