Keypad Lock - TensCare Unicare Mode D'emploi

PROGRAMME CONTROL
The button illustrated is the
programme
Unicare
programmes. At first use, the unit
automatically goes to programme
STRES. Next time it is switched on, it
will default to the programme used
last.
Each time you press and release the
PROGRAMME CONTROL button, the
programme changes and is shown
on the LCD.
Each time you
programme, the
reverts back to zero. This is a safety
feature to alleviate any sudden
feeling of a
programme gives
sensation.
TREATMENT TIMER
The button illustrated can be
used to
duration. When you switch
the unit on, it is automatically set at
20 min or Continuous, (displayed as
C) depending on the programme
chosen.
To set a different time, set the
strength to zero and press TIMER. The
min display will flash.
You can set session times of C
(Continuous) or 10, 20, 30, 45, 60 or
90 minutes with the buttons ▲ and
▼.
Press TIMER again to save your
selection.
control. The
has five preset
change the
strength level
surge, as each
a different
set the session
The LCD shows the session duration
next to the clock symbol. The unit
automatically counts down the
minutes set and switches off when it
reaches 0.
LOW BATTERY
An empty battery symbol
will show when you need to
recharge the batteries. The unit will
shut down about 2 minutes after this.

KEYPAD LOCK

If you do not press any keys
for 30 seconds, the keypad
will lock. This is to avoid accidental
changes in setting.
To unlock, press and hold the
strength down control (button ▼).
LEADS ALARM
The Unicare
connection and
between you and the probe, or the
pads. This is to prevent sudden
changes if a broken connection is
re-made. If either of these goes
outside of a standard range while
the strength is above 20, the unit will
flash LEADS and return the strength
to 0.
Check the lead and if necessary,
lubricate the probe with a water-
based lubricant such as TensCare
Go Gel (see K-GO). Please see
section 21 for more troubleshooting
tips.
25
monitors the
the contact