Keypad Lock - TensCare Uniglo Mode D'emploi

the strength, press and release the
lower part of the buttons marked
CH1▼ and CH2▼.
Caution: should be observed
when using the ALLURA at
high strength
ALLURA has a Yellow LED light on
output socket which means the
output will exceed 10 mA (R.M.S) or
10 V (R.M.S) averaged over any
period of 1 sec. Prolonged use at
high settings may cause muscle
injury or tissue inflammation.
PROGRAMME CONTROL
The button illustrated is the
programme
Uniglo has eight different,
specially developed programmes.
When the unit is first switched on it
automatically
programme FACE 1.
Each time you press and release the
PROGRAMME CONTROL button, the
programme changes and is shown
on the LCD.
Each time you
programme, the
reverts back to zero. This is a safety
feature to alleviate any sudden
feeling of a
programme gives
sensation.
PHASE SKIP
All the programmes except
FACE 1 and FACE 2 have
seven phases.
settings.
control. The
enters the
change the
strength level
surge, as each
a different
The bar column in the middle of the
display increases as each phase
starts:
Phase 1 Phase 2
And so on up to the 7
bars).
This button can be used to skip a
phase. Press and hold this button for
3 to 5 seconds to skip and go to the
next phase of
treatment session.
LOW BATTERY
An empty battery symbol will
show when you need to
charge the batteries. The unit will
shut down about 2 minutes after this.

KEYPAD LOCK

If you do not press any keys
for 30 seconds, the keypad
will lock so that only the keys marked
CH1▼ or CH2▼ will work. This is to
avoid accidental
setting. To unlock, press either CH1▼
or CH2▼ keys.
OPEN CIRCUIT CUTOUT
Uniglo
If the
connected to
strength in the channel which is not
properly connected
automatically reset to zero. This is to
30
Phase 3
phase (7
th
the selected
changes in
is not correctly
your body, the
will