Training Session; After Your Training Session - TensCare Uniglo Mode D'emploi

Vera based
treatment to soothe any skin
irritation.
2) Place the electrode pads on the
skin, see section 9.
3) If you are using your Uniglo while
moving, you can attach the unit
to your belt using the belt clip or
hang it around your neck using a
neck cord (not included). For
safety, use thread or wool that will
snap easily if the unit snags on
something.
4) You can safely lean on the
electrode pads. The sensation
might change.
Warning: Ensure the Uniglo is
switched
applying the electrode pads
on the skin.

12.4. TRAINING SESSION

1) Press and hold the ON button on
the control unit for 3 to 5 seconds
to switch the control unit on.
2) When switched on for the first
time, the Uniglo will automatically
select the programme FACE 1.
Next time, it will automatically
select the programme you were
using the last time it was switched
off.
3) You can select from the 8 preset
programmes. Details in section 8
will help you identify the best
programme to suit you.
4) Identify the
positioning for the selected area
cream after
OFF before
correct pads
and apply the electrode pads as
described in section 9.3.
5) Once the electrode pads are
correctly positioned, adjust the
intensity as described in 11.2. with
the buttons CH1▼, CH1▲, CH2▼
and CH2▲. The LCD display
shows the strength of intensity
used for each channel.
Note:
If
becomes
reduce the intensity.
12.5. AFTER YOUR TRAINING
SESSION
When the timer reaches zero, your
session is complete, and the unit
turns off.
1) Check that the control unit is OFF.
If it is not, hold down the OFF
button to switch off then remove
the electrode pads from your skin
by holding the pad itself and
gently pulling. Be careful not to
pull the wires as this may damage
them.
2) Replace the electrode pads to
their protective plastic shield and
return them to the re-sealable
plastic bag.
Note: When removing the
electrode pads, DO NOT
PULL ON LEAD WIRES.
34
the sensation
uncomfortable,