Connecting Lead Wires; Preparing For Session - TensCare Uniglo Mode D'emploi

swallowing them by mistake. If
swallowed by child, contact your
healthcare
immediately.
Battery Caution
Caution: Do NOT use in a location
where there is a large amount of
static electricity,
safety devices in the battery pack
may be compromised.
Caution: If the battery pack creates
an odour, generates heat, becomes
discoloured or deformed, or in any
way appear abnormal during use,
recharging or storage, immediately
remove it from the device or battery
charge and stop using it.
Caution: If battery leakage occurs
and comes in contact with the skin
or eyes, wash thoroughly with lots of
water and immediately
medical attention.
If necessary,
replacement battery please send
the device to Tenscare. (See back
cover for contact details)
Disposal: Always dispose of batteries
and device responsibly according
to local government guidelines. Do
not throw batteries onto a fire. Risk of
explosion.
professional
otherwise, the
seek
to obtain a
12.2. CONNECTING LEAD
WIRES
Insert the lead wire plug into the
base of the unit.
Attaching the electrode pads to the
lead wire.
Push the pin ends firmly into the
pigtail ends of the electrode pads.
The lead wires may be damaged by
rough handling and should be
treated with care.
Lead wire colour coding.
The ends of the lead wires are
coloured red or black. One of the
electrode pads
positioned over the motor point (see
section 9.3.).

12.3. PREPARING FOR SESSION

1) Before use make sure your skin is
clean and dry.
If you are
programmes,
carefully before
electrode pads, removing all
makeup, oils
Residue from these can prevent
the electrode
adhering properly. Use an Aloe
33
should be
FACE
using the
clean the skin
applying
and creams.
pads from