Krick Ro Marin Happy Hunter Notice De Montage Et De Mise En Œuvre page 48

Checking the working systems, trimming
Checking the working systems
Check once more that the motors run in the correct directions (contra-rotating propellers), and test the steering system
carefully. Check each of the installed auxiliary working systems in turn.
Assemble the model completely, ready to run, and place it in the bath (preferably half-full of water). Add lead ballast until
the boat floats evenly at the marked waterline. Check all round the hull: the model must not list (lean to one side). Use
lead sheet or lead shot as trim ballast. When you are confident that all is well, fix the lead ballast inside the hull so that it
cannot possibly shift.
Charge up the batteries, and your new model is ready for its maiden run.
We reserve the right to alter technical specifications.
Errors and omissions excepted. Modifications reserved. Copyright Klaus Krick Modelltechnik
Copying and re-printing, in whole or in part, only with prior written approval of Klaus Krick
Modelltechnik
Klaus Krick Modelltechnik
Industriestr. 1
75438 Knittlingen
Germany
© Klaus Krick Modelltechnik, Germany, Stand 06.2017