Kollmorgen SERVOSTAR 600 Mode D'emploi page 63

2.6.3.8 Motor (synchronous)
Press function key F12 (Software Disable) before changing motor parameters.
Motor Type: Select Synchronous Motor. If you use a linear motor or an induction motor,
please contact our support department.
Number-Name: Click the list to start uploading the motor parameter table, which is stored in
the servo amplifier. Search and select the connected motor. If your motor is not listed, please
contact our support department.
Leave all other fields unchanged.
Click OK.
On the start screen, click "Feedback" button.
S600 Safety Guide | 2 English
If your motor has a built-in brake,
click Yes, otherwise "No".
If Software Enable is active, a warn-
ing appears. You can proceed, but
after the amplifier is restarted, you
must check whether the holding
brake configuration is correct.
Click OK.
Parameters are uploaded to the amp-
lifier's RAM now (takes some
seconds). When this is done, you
have to accept the changed con-
figuration with "Yes" or to discard
the changes in the appearing screen.
If you click "Yes", the parameters
are saved in the EEPROM and the
amplifier makes a coldstart (reset).
This takes some seconds.
Kollmorgen | wiki-kollmorgen.eu | December 2015 63