Mounting The Striking Plate - Assa Abloy effeff 309 Notice D'installation Et De Montage

Fasten the locking
cylinder with the
cylinder fixing screw
Check for complete
functionality
Pic. 6 :
No transverse shear
stress on the bolt after
installation
Installation

Mounting the striking plate

The striking plate must be installed in the door frame so that the latch bolt and the control latch can slide
over a level surface. The control latch must be pressed in continuously in the process.
1 Create the striking plate pocket and finish all holes in accordance with Pic. 10. Alternatively, finish a
customer-provided striking plate ("Finishing customer-provided striking plates", page 45).
2 Clean the striking plate pocket and all holes by blowing them out or vacuuming.
3 Screw in the appropriate locking plate for the security lock 309 to be screwed in. Stack multiple striking
plates in order to appropriately adjust the rebate gap.
4 Test the security lock 309 for ease of movement.
 The security lock 309 is ready for use.
Mounting fittings and locking cylinders
1 Mount the fittings.
2 Place the lock cylinder in, and keep in mind that the cylinder's locking nose is in the middle position
(Pic. 8).
3 Fix the locking cylinder into place with the fixing screw.
 The security lock 309 is completely mounted.
Testing the security lock 309
1 Test all functions of the security lock 309.
2 Check whether the latch and auxiliary latch bolt of the lock are pushed back by the same impact edge.
3 Check whether all bolts can freely extend and retract without transverse shear stress after installation
(Pic. 6).
 The security lock 309 is completely assembled and tested for functionality.
Striking plate
F
= 0
Q
N
min. 2
F
= 0
Q
N
Face plate
EN
43