Changing The Program Mid-Cycle - FAR LVIF1119A++49M Manuel D'utilisation

ENGLISH
Pre-wash
ECO 5/25 g
Wash(45°C)
(*EN (1 or 2
Rinse(60°C)
50242) pieces)
Drying
Wash(65°C)
Rinse 30g
Rinse(65°C) (1 piece)
90 mins
Drying
Wash(45°C)
Rinse(50°C) 25g
Rapid
Rinse(55°C)
NOTE:
EN 50242: This program is the test cycle. The
information for comparability test in accordance
with EN 50242.
Starting A Cycle Wash
1. Draw out the lower and upper basket,
load the dishes and push them back. It is
commended to load the lower basket first,
then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power
supply refer to last page "Product fiche".
Make sure that the water supply is turned on
to full pressure.
GB-62
190 0.9 11
90 1.35 12.5
30 0.75 11
4. Open the door, press the Power button, to
switch on the machine.
5. Choose a program, the response light will
turn on. Then close the door, the dishwasher
will start its cycle.

Changing The Program Mid-cycle

A wash cycle can only be changed if it has
been running for a short time otherwise, the
detergent may have already been released and the
dishwasher may have already drained the wash
water. If this is the case, the dishwasher needs
to be reset and the detergent dispenser must
be refilled. To reset the dishwasher, follow the
instructions below:
1. Open the door a little to stop the dishwasher,
after the spray arm stop working, you can
open the door completely.
2. Press Program button more than three
seconds the machine will be in stand by state.
3. You can change the program to the desired
cycle setting.
3 sec
ENGLISH
GB-63