Free Standing Installation; Built-In Installation (For The Integrated Model) - FAR LVIF1119A++49M Manuel D'utilisation

ENGLISH
adjustment of the screwing level of the feet.
In any case, the appliance should not be inclined
more than 2°.
NOTE:
Only apply to the free standing dishwasher.

Free Standing Installation

Fitting between existing cabinets
The height of the dishwasher,
845 mm, has been designed
in order to allow the machine
to be fitted between existing
cabinets of the same height in
modern fitted kitchens. The
feet can be adjusted so that
correct height is reached.
The laminated top of the
machine does not require
any particular care since it is
heatproof, scratchproof and
stain proof.
GB-28
Underneath existing work top
(When fitting beneath a work
top)
In most modern fitted
kitchens there is only one
single work top under which
cabinets and electrical
appliances are fitted. In this
case remove the work top of the dishwasher by
unscrewing the screws under the rear edge of the
top (a).
Attention
After removing the work top, the screws must be
screwed again under the rear edge of the top (b).
The height will then be reduced to 815 mm,
as scheduled by the International Regulations
(ISO) and the dishwasher will fit perfectly under
the kitchen working top
Built-In Installation (for the integrated
model)
Step 1. Selecting the best location for the
dishwasher
The installation position of dishwasher should be
near the existing inlet and drain hoses and power
cord.
ENGLISH
GB-29