FAR LVIF1119A++49M Manuel D'utilisation page 56

ENGLISH
Full-integrated model
Install the hook on the aesthetic wooden panel
and put the hook into the slot of the outer door
of dishwasher (see figure A). After positioning
of the panel, fix the panel onto the outer door by
screws and bolts (See figure B).
GB-32
1. Take away the four short screws
2. Pin up the four long screws
Step 3. Tension adjustment of the door spring
1. The door springs are set at the factory to the
proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to
adjust the door spring tension. Rotate the
adjusting screw to drive the adjustor to strain
or relax the steel cable.
2. Door spring tension is correct when the
door remains horizontal in the fully opened
position, yet rises to a close with the slight
lift of a finger.
Step 4. Dishwasher installation steps
Please refer to the specified installation steps in
the installation drawings.
1. Affix the condensation strip under the
work surface of cabinet. Please ensure the
condensation strip is flush with edge of work
ENGLISH
GB-33