FAR LVIF1119A++49M Manuel D'utilisation page 57

ENGLISH
surface. (Step 2)
2. Connect the inlet hose to the cold water
supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position. (Step 4)
6. Level the dishwasher. The rear food can be
adjusted from the front of the dishwasher by
turning the Philips screw in the middle of
the base of dishwasher use an Philips screw.
To adjust the front feet, use a flat screw driver
and turn the front feet until the dishwasher is
level. (Step 5 to Step 6)
7. Install the furniture door to the outer door of
the dishwasher. (Step 7 to Step 10)
8. Adjust the tension of the door springs by
using an Allen key turning in a clockwise
motion to tighten the left and right door
springs. Failure to do this could cause
damage to your dishwasher. (Step 11)
9. The dishwasher must be secured in place.
There are two ways to do this:
A. Normal work surface: Put the installation
hook into the slot of the side plane and secure
it to the work surface with the wood screws.
GB-34
B. Marble or granite work top: Fix the side with
Screw.
A
B
Step 5. Levelling the dishwasher
Dishwasher must be level for proper dish rack
operation and wash performance.
1. Place a spirit level on door and rack track
inside the tub as shown to check that the
dishwasher is level.
2. Level the dishwasher by adjusting the three
levelling legs individually.
3. When level the dishwasher, please pay
attention not to let the dishwasher tip over.
ENGLISH
GB-35