After Use; Shutting Down The Diesel Engine; Shutting Down The Lpg Engine; Shutting Down The Petrol Engine - Nilfisk Advance 56511710 Mode D'emploi

revised 3/2020

AFTER USE

1. Raise the scrub brushes and the brooms.
2. Shake the dust control fi lter and empty the hopper.
3. Drain and fl ush the recovery tank. Check that the drain hose cap is sealed.
4. Flush the vacuum hose and squeegee by opening the recovery tank lid and running water down the pickup tube on the rear of the tank.
SERVICE NOTE: The recovery tank can be tipped out to the side for cleaning after emptying. Unlatch the Recovery Tank Tip-Out Lock (3)
between the solution and recovery tank and then pull out on the tank with Recovery Tank Tip-Out Grip (25) until the tank reaches the end of
its tether.
5. Remove and clean the squeegee tool.
6. Remove and clean the scrub brushes. Rotate the scrub brushes.
NOTE: Replace scrub brushes if half of the original length is used up.
7. Wipe the machine with a damp cloth.
8. Perform all required maintenance before storage. See the "Maintenance Schedule" located on the next page.
9. Move the machine to a clean, dry storage area.
10. Apply the parking brake.
11. Store the machine with the brooms, the squeegee and the scrub brushes in the UP position, and the tank covers open so that the tanks can
air out.
Report any defect or malfunction noted during operation to Authorized Service or Maintenance Personnel.

SHUTTING DOWN THE DIESEL ENGINE

1. Put all controls to the OFF position.
2. Raise the squeegee, the scrub brushes, and the brooms.

SHUTTING DOWN THE LPG ENGINE

1. Put all controls to the OFF position.
2. Raise the squeegee, the scrub brushes, and the brooms.
3. Turn the service valve on LPG fuel tank OFF.

SHUTTING DOWN THE PETROL ENGINE

1. Put all controls to the OFF position.
2. Raise the squeegee, the scrub brushes, and the brooms.
IMPORTANT NOTE FOR LPG MACHINES ONLY:
(1-3 seconds) after turning the key OFF until all fuel is dispelled from fuel system.

CHECK HYDRAULIC OIL

To check the hydraulic oil level, swing open the Right Side Door (35) and lift out the Lower Cover (34). The Hydraulic Oil Reservoir (49) will be
visible in the area above the front tire. Look through the translucent reservoir to check the oil level it should be between the MIN and MAX lines.
See Figure 13.
If the oil level is below the MIN line with the hopper in the down position you will need to add oil to the reservoir. Raise the hopper and engage the
hopper safety bar to access the hydraulic oil reservoir fi ll cap. Note: With the hopper raised some oil has entered the cylinder causing the oil level
to drop, DO NOT fi ll the reservoir to the MAX line with the hopper raised. Add oil (see below for correct type) until the oil is at the MIN level line.
Change the oil if major contamination from a mechanical failure occurs.
MACHINE SERIAL NUMBER
Before serial number
1000068525
After serial number 1000068524
4/2017
During normal operation the engine will continue to run for a short period of time
OIL TYPE
SAE 10W30
ISO 32 all-season
hydraulic oil
FIGURE 13
INSTRUCTIONS FOR USE
3. Apply the Parking Brake (38).
4. Turn the Key Ignition Switch (A) OFF and remove the key.
4. Let the engine idle until all the LPG gas is dispelled from the line.
5. Apply the Parking Brake (38).
6. Turn the Key Ignition Switch (A) OFF and remove the key.
3. Apply the Parking Brake (38).
4. Turn the Key Ignition Switch (A) OFF and remove the key.
56091206 - CS7010
ENGLISH - A
A - 29