Preparing The Machine For Use; Pre-Operational Checklist - Nilfisk Advance 56511710 Mode D'emploi

A - ENGLISH

PREPARING THE MACHINE FOR USE

Read pages 15 – 20 for preparing the machine for use.

PRE-OPERATIONAL CHECKLIST

NOTE: Refer to pages A-8 – A-12 for the reference numbers and letters called out below.
When
Before Each Use
►
►
►
►
►
►
►
►
►
►
►
In the Driver's Seat
►
►
►
►
As Needed
►
Plan Your Cleaning in Advance
►
►
►
A - 16
INSTRUCTIONS FOR USE
Action Required
Inspect the machine for damage, oil or coolant leaks.
Squeeze the rubber dust cup on the Engine Air Filter (48) to release built-up dust.
Check the Air Filter Service Indicator (29).
Check the engine coolant level (22).
Check the engine oil level (50).
Check the hydraulic fl uid level.
Check the Fuel Gauge (C14) on the diesel and petrol models.
Check the Fuel Gauge located on the LPG tank (31) for propane model.
Check the Battery Charge Level (C3) on battery models.
Make sure the battery charger is not connected to the machine.
Make sure the recovery tank is empty.
Be sure that you understand the operating controls and their functions.
Adjust the seat to allow easy reach of all controls.
Turn the (Ignition) Key Switch (A) to the ON position. Check for proper operation of the Horn (M), Hour Meter
(C1) and Headlights (L). Turn the Key Switch (A) to the OFF position.
Check the Brake Pedal (38). The pedal should be fi rm and should not go all the way down. The latch should hold
the pedal when applied.
Report all defects immediately to service personnel.
Arrange long runs with a minimum of stopping or starting.
Allow 6 inches (15 cm) of broom path overlap to ensure complete coverage.
Avoid making sharp turns, bumping into posts or scraping the side of the machine.
CS7010 - 56091206 4/2017