Name Plate; Prepare The Machine For Use; (B) Installing The Batteries; (C) Installing The Brush Or Pad - Nilfisk Advance BA 5321/D Mode D'emploi Et D'entretien

NAME PLATE

The machine Model and Serial Number are shown on
the plate on the machine itself. This information is nee-
ded when ordering spare parts for the machine. Use
the space below to note the machine Model and Part
Number for future reference.
MODEL......................................................................
PART NO ..................................................................
PREPARE THE MACHINE FOR
USE

(B) INSTALLING THE BATTERIES

WARNING!
Use extreme caution when working with
batteries. Sulphuric acid in batteries can
cause severe injury if allowed to contact
the skin or eyes. Explosive hydrogen gas
is vented from the batteries through ope-
nings in the battery caps. This gas can be
ignited by spark or flame.
When servicing batteries
– Remove all jewels
– Do not smoke
– Wear safety glasses
– Work in a well ventilated area
– Do not allow tools to touch more than one battery
terminal at a time
CAUTION!
The electric components of this machine
can be seriously damaged if batteries are
either installed or connected improperly.
Batteries can be installed by qualified per-
sonnel only.
Set the machine according to the battery
type to install (WET for lead/acid batteries,
GEL for hermetic gel batteries) by means
of the 26 selector Fig. A. Set the battery
charger according to the same battery
type, by means of the selector on the bat-
tery charger panel
1. Check the batteries
installation.
2. Disconnect the battery charger plug from the
electrical system.
08812648(3)2003-02
INSTRUCTION MANUAL FOR USE AND MAINTENANCE
for damage before
3. Carefully lift the batteries and place them as
shown in fig. B.
4. Be sure that the battery charger cables are
properly connected to the battery terminals
according to their polarity.
5. Install the battery terminal protection caps
supplied with the machine.
6. 6. Charge the batteries as indicated in paragraph
J.

(C) INSTALLING THE BRUSH OR PAD

WARNING!
Moving parts: Turn all switches and the
key (*) to 0 position (OFF) before any ser-
vice operation.
* BA5321D - BA6124D
IMPORTANT!
1. If using a pad, install it on the pad holder first.
2. Raise the brush deck in the upper position.
3. Place brush/pad-holder under the raised brush
deck.
4. Lower the brush pedal.
5. Turn the brush switch to I position (ON)
6. Push and release the drive panel to engage the
brush/pad-holder.

(D) INSTALLING THE SQUEEGEE

1. Install the squeegee on the bracket.
2. Tighten the thumb nuts securely.
3. Connect the hose.

(E) FILLING THE SOLUTION TANK

1. Fill the solution tank with an appropriate cleaning
solution.
2. Do not overfill the solution tank.
3. Always follow the dilution instructions on the
chemical container label.
4. The detergent temperature must not exceed
100°F (40°C).
CAUTION!
Use only low-foam and non-flammable de-
tergent liquids, intended for automatic
scrubber applications.
5