Operating The Machine; Startup Homing Sequence; Starting The Diesel Engine; Starting The Lpg Engine - Nilfisk Advance 56511710 Mode D'emploi

A - ENGLISH

OPERATING THE MACHINE

The CS7010 is a rider-type automatic fl oor sweeping and scrubbing machine. It is designed to sweep up debris, lay down cleaning solution,
scrub the fl oor, and vacuum dry all in one pass. The sweeping and scrubbing operations can also be performed separately.
The controls were designed with one touch operation in mind. For single pass scrubbing the user can simply depress one switch and all scrub
functions on the machine will be enabled. For sweeping, the operator can simply depress one switch and all sweeping functions will be enabled.
NOTE: Bold numbers or letters in parentheses indicate an item illustrated on pages 6-10.

STARTUP HOMING SEQUENCE

When the machine is powered, the drive wheel will turn all the way to the left and then all the way to the right to locate the home position. This
will take less than 2 seconds. The steering wheel does not move during this process only the drive (rear) wheel. This startup homing sequence
helps set the home position which in-turn facilitates the max. speed limiting in very sharp turns to improve the overall drivability and safety of the
machine.
WARNING!
Keep hands clear of rear wheel assembly when key is turned on.

STARTING THE DIESEL ENGINE

1. Turn the key switch (A) clockwise to the RUN (ON) position. The glow plugs will activate for 10 seconds as indicated by the glow plug icon
on the display. If the engine is already warm, turn the key switch to the start position to crank the engine. If the engine is cold, wait for the
glow plug icon to turn off before cranking the engine. The engine should start immediately. If the engine does not start within 15 seconds
release the key, wait for approximately one minute and repeat the above steps.
2. Let the engine run at IDLE speed for fi ve minutes before using the machine.

STARTING THE LPG ENGINE

1. Open the service valve on the LP fuel tank.
2. Turn the Ignition Key Switch (A) clockwise to the START position and release it as soon as the engine starts. If the engine does not start
after cranking for 15 seconds, release the key, wait for 1 minute, then try again.
3. Let the engine run at "IDLE" speed for 5 minutes before using the machine.

ENGINE FAULT CODE FOR DIESEL AND LPG ENGINES ONLY

NOTE: If If the engine has been running for at least 3 seconds and the run signal is lost while the key switch is still in the run/on position,
then the 1-303 fault code (Eng No Run Signal) will be set and the display will alternate between the Engine Fault Indicator (C38) and the
Oil Pressure Indicator (C27). See the Service Manual for troubleshooting information.

STARTING THE PETROL ENGINE

1. Turn the Ignition Key Switch (A) clockwise to the START position and release it as soon as the engine starts. If the engine does not start
after cranking for 15 seconds, release the key, wait for 1 minute, then try again.
2. Let the engine run at "IDLE" speed for 5 minutes before using the machine.
The Engine Speed (RPM) will automatically adjust depending upon load. Use the Drive Pedal (37) not the Engine Speed Switch (K) to
control the speed of the machine. The speed of the machine will increase as the pedal is pushed closer to the fl oor. Do not press the Drive
Pedal (37) until the engine has started.
A - 22
INSTRUCTIONS FOR USE
CS7010 - 56091206 4/2017