Side Skirt Maintenance - Nilfisk Advance 56511710 Mode D'emploi

SIDE SKIRT MAINTENANCE

CAUTION!
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
The side skirt's function is to channel the waste water to the squeegee, helping contain the water within the machines cleaning path. During
normal use the blades will wear in time. NOTE: The blades on each skirt assembly are held on with Tool-less Retainers.
To reverse or replace the leading deck blade (JD):
1. See Figure 22. Loosen Retainer Knob (40) and swing the Edge Guard (JA) open as shown. NOTE: Edge Guard is only on the right side
deck skirt.
2. Remove the two Wing Knobs (JB). Remove the Strap Weldment (JC) and the Leading Deck Blade (JD) from the inside of the skirt.
3. The leading deck blades have 4 working edges as shown. Turn the blades so a clean, undamaged edge faces toward the center of the
machine. Replace the blades as a set if all working edges are nicked, torn or worn excessively.
4. Follow the steps in reverse to install the leading deck blade.
To reverse or replace the trailing deck blade (JG):
1. See Figure 22. Loosen Retainer Knob (40) and swing the Edge Guard (JA) open as shown. NOTE: Edge Guard is only on the right side
deck skirt.
2. Unlatch the Latch Assembly (JE) at the rear of the skirt assembly. Swing out the Retainer Strap (JF) and unhook at the front of the skirt
assembly. Remove the Trailing Deck Blade (JG) from the skirt assembly.
3. The trailing deck blades have 2 working edges. Flip the blade so a clean, undamaged edge faces toward the center of the machine. Replace
the blades as a set if both working edges are nicked, torn or worn excessively.
4. Follow the steps in reverse to install the trailing deck blade.
FIGURE 22
JG
JE
JF
4/2017
INSTRUCTIONS FOR USE
40
JB
JC
JD
JA
56091206 - CS7010
ENGLISH - A
A - 39