Side Broom Maintenance; Dustguard Nozzle Cleaning Procedure - Nilfisk SW8000 Mode D'emploi

A-16 / ENGLISH

SIDE BROOM MAINTENANCE

To adjust the Side Broom...
1 Drive the machine to an area with a level À oor and set the parking brake.
2 Pull the Main Broom Lever (B) back and slide to the right and up to lower the main and side brooms.
3 See Figure 2. When in the Down position, the Right Side Broom (9) should be contacting the À oor from the 10 O'Clock (A1) to the 3 O'Clock
(A2) area shown. NOTE: Optional Left Side Broom (31) should be contacting the À oor from the 9 O'Clock (A3) to the 2 O'Clock (A4) area.
4 If either broom requires adjustment, turn the Side Broom Height Adjustment Knob (10) either clockwise to raise or counter-clockwise to lower
the side broom.
NOTE: The machine should be stored with the Side Brooms (9 & 31) in the raised position. The Side Brooms (9 & 31) should be replaced when
the bristles are worn to a length of 3 inches (7.62 cm) or it becomes ineffective. The Side Broom height must be re-adjusted whenever a broom
has been replaced.

DUSTGUARD NOZZLE CLEANING PROCEDURE

To prevent nozzle plugging remove nozzle(s) after each daily use and soak overnight in clean white vinegar or appropriate calcium/lime remover.
To avoid machine downtime best practice is to purchase spare nozzle(s) and replaced those that have just been used with those that have been
cleaned. When nozzles can no longer be cleaned effectively replace as necessary.
FIGURE 2
A-16 - FORM NO. 56091188 - SW8000
revised 8/2018
4/2015