Charging The Battery Pack (Hybrid Models) - Nilfisk Advance 56511710 Mode D'emploi

CHARGING THE BATTERY PACK (HYBRID MODELS)

The engine runs a generator which is the main source of electrical power. The battery pack (32) is used as a back-up. If the engine is not running,
the machine can operate for a limited time using only the battery pack. Charge the battery pack whenever the Battery Low Indicator (C12) is
displayed (signifying a low-voltage cutout state). The battery pack can be recharged by running the engine and scrubbing with the machine for at
least four hours. An alternative is to follow the steps below to charge the battery pack using a shelf charger.
To Charge the Battery Pack:
1. Unlatch and open the Right Side Door (35).
2. See Figure 16. Pull the yellow Handle (DG) to disconnect the battery pack from the machine at plug (DH).
3. Connect the charger plug to the battery plug (DH).
4. Follow the instructions on the battery charger; use an appropriate charger for gel batteries.
CAUTION!
Use only Nilfi sk approved 36 V gel battery charger.
Never leave the machine in a low-voltage cutout state overnight without charging the battery pack.
FIGURE 16
DG
4/2017
32
INSTRUCTIONS FOR USE
DH
56091206 - CS7010
ENGLISH - A
A - 33