Installation Of The Battery Pack; New Battery Pack Set-Up - Nilfisk Advance Whirlamatic 2700 Mode D'emploi

A-6 / ENGLISH

INSTALLATION OF THE BATTERY PACK

WARNING!
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin or
eyes. Explosive hydrogen gas is vented from inside the batteries through openings in the battery caps. This gas can be ignited by
any arc, spark or flame.
WHEN SERVICING BATTERIES...
• Remove all jewelry
• Do not smoke
• Wear safety glasses
• Work in a well-ventilated area
• Do not allow tools to touch more than one battery terminal at a time
CAUTION!
Acid can spill onto the floor if the batteries are overfilled.
To avoid damage to floor surfaces, wipe water and acid from the top of the batteries after charging.
Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Batteries should be installed by your
local Nilfisk-Advance Distributor or by a qualified electrician.

NEW BATTERY PACK SET-UP

1 See Figure 1. Pull the Battery Tray (A) and the Battery Box (B) out of the machine chassis and center the assembly on a pallet jack with the side rails
of the Battery Box (B) parallel to the pallet jack forks. IMPORTANT: The Battery Box (B) must be on the pallet jack before placing the batteries in the
Battery Tray, or you will not be able to get a pallet jack under the Battery Box. NOTE: A 27" (68 cm) or narrower pallet jack is required, a pallet jack any
wider will not work!
2 Place the batteries into the Battery Tray and connect the Battery Cables (C) as shown. Connect the Connector Assembly (D) as shown (black cable to
negative terminal / red cable to positive terminal).
3 Install the Battery Post Boots (E). Secure tightly to battery cables with supplied tie straps.
4 Raise the jack until the battery box will clear the side rails in the chassis and then roll the battery box into the battery compartment until it contacts the other
side of the chassis and then lower it onto the side rails in the chassis.
5 Connect the Battery Pack Connection (7). Open the Battery / Controller Compartment Cover (21) to provide proper ventilation.
6 Push the connector from the charger into the Machine Battery Charger Port (16). Follow the instructions on the battery charger.
7 Check the fluid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the fluid level up to the bottom of the filler
tubes.
A-6 - FORM NO. 56041404 - Whirlamatic
™
2700 / BHS 7014