Engine Oil -Petrol, Lpg; Engine Oil - Diesel; Engine Break-In Period -Petrol, Lpg; Engine Coolant - Nilfisk Advance 56511710 Mode D'emploi

ENGINE OIL – PETROL, LPG
Check the engine oil level when the machine is parked on a level surface and the engine is cool. Change the engine oil after the fi rst 50 hours of
operation and every 200 hours after that. Use any SF or SG rated oil meeting API specifi cations and suited to seasonal temperatures. Refer to
the Engine Workshop manual for oil capacities and additional engine specifi cations. Replace the oil fi lter with every oil change.
OIL TYPE
SF or SG rated oil meeting API
specifi cations and suited to seasonal
temperatures.
ENGINE OIL – DIESEL
Check the engine oil level when the machine is parked on a level surface and the engine is cool. Change the engine oil after the fi rst 50 hours
of operation and every 200 hours after that. Use CF, CF-4 or CG-4 oil meeting API specifi cations and suited temperatures (*important reference
the oil/fuel type note below for further diesel oil recommendations). Refer to the Engine Workshop manual for oil capacities and additional
engine specifi cations. Replace the oil fi lter with every oil change.
OIL TYPE
CF, CF-4 or CG-4 rated oil meeting API
specifi cations and suited to seasonal
temperatures.
* Diesel Lubricating Oil Note:
With the emission control now in effect, the CF-4 and CG-4 lubricating oils have been developed for use with a low-sulfur fuel used in on-road
vehicle engines. When an off-road vehicle engine runs on a high-sulfur fuel, it is advisable to employ the CF, CD or CE lubricating oil with a
high total base number. If the CF-4 or CG-4 lubricating oil is used with a high-sulfur fuel, change the lubricating oil at shorter intervals.
• Lubricating oil recommended when a low-sulfur or high-sulfur fuel is employed.
Fuel
Lubricating
Oil class
CF
CF-4
CG-4
O : Recommended X : Not recommended
ENGINE BREAK-IN PERIOD –PETROL, LPG
During initial engine break-in period you may experience a slight smell or small amount of smoke coming from the engine.

ENGINE COOLANT

CAUTION!
Do not remove the radiator cap when the engine is hot.
To check the engine coolant level, unlatch the Engine Compartment Access Panel Latch (10) and remove the side panel, and observe the coolant
level in the Engine Coolant Reservoir (22). If the level is low add automotive type anti-freeze appropriately diluted for the environment. Clean the
radiator exterior by washing with low-pressure water or using compressed air every 30 hours.
4/2017
TEMPERATURE RANGE
Above 77 °F (25 °C)
32 °F to 77 °F (0 °C to 25 °C)
Below 32 °F (0 °C)
TEMPERATURE RANGE
Above 77 °F (25 °C)
32 °F to 77 °F (0 °C to 25 °C)
Below 32 °F (0 °C)
Low sulfur
High sulfur
(0.5 % ≥)
O O
O X
O X
INSTRUCTIONS FOR USE
Remarks
TBN ≥ 10
56091206 - CS7010
ENGLISH - A
OIL WEIGHT
SAE 30 or SAE 10W-30
SAE 20 or SAE 10W-30
SAE 10W or SAE 10W-30
OIL WEIGHT
SAE 30 or SAE 10W-30
SAE 20 or SAE 10W-30
SAE 10W or SAE 10W-30
A - 17