Battery Installation; Important - Nilfisk Advance 56511710 Mode D'emploi

BATTERY INSTALLATION

See Figure 5. The battery required for this machine is sold separately. The maximum battery weight for this machine is 1,875 lbs (850 kg); the
minimum battery weight is 1,400 lbs (635kg). For proper battery installation, please consult your Advance Industrial Dealer. DO NOT attempt to
install the battery with an overhead hoist or forklift; it can only be installed with a battery cart. Connect the connector plug (AB) on the battery to
the machine plug behind the steering wheel. Make sure the battery is fi rmly seated against the brace on the left side of the battery compartment.
Reinstall the battery Stop Plate (AC) on the right side of the compartment and snug up the Bumpers (AD) so the battery cannot slide from side-to-
side.
NOTE: If the Stop Plate (AC) is not in place, machine functions will be disabled and the Battery Interlock Open Indicator (C37) will fl ash.
WARNING!
Battery weight in excess of 1,875 lbs (850 kg) or below 1,400 lbs (635kg) may cause the premature failure of parts including the
tires, and may result in decreased stability and control, which could cause personal injury or death and/or property damage. Use of a
battery in excess of the weight limit will void the warranty.

IMPORTANT!

Follow instructions packed with the battery and charger before charging the battery. Read the instructions for Charging the Battery in
the Maintenance section of this manual.
FIGURE 5
AB
4/2017
INSTRUCTIONS FOR USE
AD
56091206 - CS7010
ENGLISH - A
AC
A - 19