Hydraulic Oil; Engine Oil - Nilfisk Advance Proterra 13300106 Instructions D'utilisation

ENGLISH

HYDRAULIC OIL

WARNING!
Do not touch hot components.
Let the engine and hydraulic system cool down.
1. Drive the machine on a level fl oor, engage the parking brake
and turn the ignition key (64) to "O".
2. Open the engine compartment hood (1) by using the
unlocking push-button (25).
3. Remove the left side hood (4) by using the latch, if
necessary remove the water fi lter hose (30, optional).
4. Check the hydraulic oil level by means of the indicator on
the tank (19).
The hydraulic oil level should be half way up the indicator.
If it is below this level, unscrew the plug (20) and add
Hydraulic oil AGIP Arnica 46.
Change the oil if major contamination from a mechanical
failure occurs (see the procedure in the Service Manual).

ENGINE OIL

WARNING!
Do not touch hot components.
Let the engine cool down.
1. Drive the machine on a level fl oor, engage the parking brake
and turn the ignition key (64) to "O".
2. Open the engine compartment hood (1) by using the
unlocking push-button (25).
3. Check the engine oil level with the dipstick (A, Fig. 8-9-10)
before each use of the machine.
If necessary, open the plug (B, Fig. 9-10) and top up.
(See the procedure in the Engine Manual).
4. Change the engine oil after the fi rst 50 hours of operation,
and then after 150 hours.
The oil fi lter (C) should be replaced with every oil change
(see the procedure in the Service Manual).
According to the air temperature, use the type of oil
indicated below:
TEMPERATURE RANGE
Above 60°F (15°C)
Below 60°F (15°C)
28
INSTRUCTION FOR USE
TYPE OF OIL
SAE 10W-30
SAE 5W-30
33019864(1)2009-05
Proterra™ Diesel version
C
Proterra™ LPG and Gasoline version
Proterra™
A
MAX
MIN
Figure 8
A
Figure 9
Figure 10
P100329A
B
C
P100329D
B
A
P100329P