Operating The Machine; Starting The Machine; Stopping The Machine - Nilfisk Advance SC5000 34D Mode D'emploi

A - ENGLISH

OPERATING THE MACHINE

WARNING!
Be sure you understand the operator controls and their functions.
While on ramps or inclines, avoid sudden stops. Avoid abrupt sharp turns. Use low speed down ramps.

STARTING THE MACHINE

1 Follow the instructions in "Preparing the Machine for Use" section of this manual and verify the following;
• Batteries are fully charged.
• Exterior of machine is free of damage. Report any damage to your supervisor.
• Proper brushes is correctly installed.
• Squeegee is installed.
• Solution tank is full.
• Recovery tank is empty.
• Ensure that area to be scrubbed is clear of obstacles that are not fixed, such as hoses, buckets or pails, boxes, electrical cords, carts,
pallets, etc.
WARNING!
Do not dispense flammable cleaning agents, operate the machine on or near these agents, or operate in areas
where flammable liquids exist.
C10
2 Refer to illustrations on pages 8-11 if needed. Sit in the Operator's Seat (2), adjust the seat to a comfortable position using the Seat
Adjustment Lever under the seat.
3 Place the Magnetic SmartKey (39) into the SmartKey Reader (22) on the machine. Press the
Power Switch (H) to turn ON the machine.
Reference the Battery Indicator (C3). and Hour Meter (C1) before proceeding.
4
5 To transport the machine to the work area apply even pressure with your foot to the front of Drive
Pedal (3) to go forward. For reverse, first press Reverse Paddle (D). Reverse Indicator (C27) will
appear on the display then apply even pressure with your foot to the front of Drive Pedal (3). An
audible alert will sound in reverse.
Adjust machine speed by varying the pressure on the Drive Pedal (3).
6

STOPPING THE MACHINE

Stop the machine by releasing the Drive Pedal (3).
1
C5
2 After releasing the Drive Pedal the Brake Pedal (40) can be pressed to help stop the machine.
3 ONLY IN THE EVENT OF AN EMERGENCY!
To stop all machine functions immediately, press the Emergency Stop (A).
• The display will show Emergency Stop Activated Indicator (C20).
• To reset the machine functions, rotate the emergency stop clockwise.
24
A - 24
INSTRUCTIONS FOR USE
C1
M+
C3
O
N
M
M-
L
25
28
Advance SC5000 - 56091219
C25
B
C
C16
H
K
J
C11
C12
C9
C10
C6
C24
F+
D
C17
E
F
F-
G
C5
C7 C8
C27 C14
C18 C19
1/2021