Squeegee Installation - Nilfisk Advance SC5000 34D Mode D'emploi

SQUEEGEE INSTALLATION

1 See Figure 2-6. Ensure the Squeegee Seal (AA) is free from debris and installed on the Squeegee Assembly (33). Lift the squeegee
assembly by its Handles (AB) and slide it onto the Squeegee Mount (AC) and tighten the Squeegee Mount Thumb Nuts (31).
Connect the Recovery Hose (29) to the squeegee mount (AC).
2
3 Lower the squeegee and move the machine ahead slightly. Check that the rear squeegee blade touches the floor evenly across its entire
width and is bent over slightly as shown in the squeegee cross section (AD). If necessary adjust the rear squeegee to the proper height and
tilt by following the steps in the "Squeegee Adjustment" section.
FIGURE 2-6
AB
1/2021
INSTRUCTIONS FOR USE
31
AA
33
56091219 - Advance SC5000
29
31
AC
AB
ENGLISH - A
AD
A - 19