Squeegee Installation - Nilfisk ECOFLEX BA 651 Manuel D'utilisation

Squeegee installation

1. Install the squeegee (25) and fasten it with the handwheels (26), then connect the vacuum hose (15) to the squeegee.
2. Adjust the squeegee with the handwheel (27) so that the rear blade - in all its length - touches the fl oor.
Guide to match squeegees and brush/pad-holder decks
Model Deck
BA 601 Deck with two brushes (18), brush diameter 305 mm
(*)
BA 651 Deck with two brushes (18), brush diameter 330 mm
BA 751 Deck with two brushes (18), brush diameter 355 mm
BA 851 Deck with two brushes (18), brush diameter 430 mm
BA 751C Deck with two cylindrical brushes (19), brush length 690 mm
(*) Optional model
Solution or washing water tank fi lling
NOTE
If the machine is equipped with EcoFlex™ system (optional) (switches (83 and 77) activated) pour clean water in the
tank, otherwise pour solution.
1. Remove the plug (47) to reach the fi ller (8).
2. (For machine without EcoFlex™ system)
Fill the tank (20) with a solution suitable for the work to be performed.
Do not fi ll the tank completely, leave a few inches from the edge. Use the removable hose (17) as reference.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
WARNING!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
(For machine with EcoFlex™ system)
Fill the tank (20) with clean water by using the fi ller neck (8).
Do not fi ll the tank completely, leave a few inches from the edge. Use the removable hose (17) as reference.
The water temperature must not exceed 40 °C.
Detergent tank fi lling
(For machine with EcoFlex™ system)
1. Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16).
2. Grasp the handle (41) and carefully lift the tank (40).
3. Open the plug (46).
4. Fill the tank (45) with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not fi ll the detergent tank completely, leave a few inches from the edge.
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
NOTE
In case of new system, system emptied for cleaning, etc., wait for the hoses to fi ll up completely before turning on. In
order to fi ll the system quickly it may be useful to drain the EcoFlex™ system once or several times (see the procedure in
Maintenance chapter).
BA 651 - BA 751 - BA 851 - BA 751C
USER MANUAL
Squeegee model
Aluminium width 838 mm
Aluminium width 889 mm
Aluminium width 889 mm
Aluminium width 1,067 mm
Aluminium width 889 mm
9097293000(3)2010-03 A
ENGLISH
17