ENGLISH
BEFORE MACHINE START-UP
20 21
22
16
17
18
25 26
15 27
WARNING!
When the machine is to be started by turning the ignition key (80) to "I", make sure that, between the deck (18
or 19) and the above tank assembly, there is no foreign material which may prevent the deck from lifting. This
procedure must be performed because if the machine has been turned off without lifting the deck, the deck
would lift automatically at next machine start-up.
WARNING!
Before turning on the deck lifting/lowering switch (71), always check that, between the deck (18 or 19) and the
above tank assembly, there is no foreign material which may prevent the deck from lifting.
Brush/pad-holder deck or cylindrical brush deck installation/removal
The machine can be equipped with either the brush/pad-holder deck (18) or the cylindrical brush deck (19).
For deck installation/removal see the procedure in Maintenance chapter.
NOTE
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the
same width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph.
14
USER MANUAL
3
4
71
71
BA 751C
26
9097293000(3)2010-03 A
75
83
80
BA 651, BA 751, BA 851
46
45
BA 651 - BA 751 - BA 851 - BA 751C
77
47
8
40
41
20
19
P100172B