VACUUM SYSTEM MOTOR FILTER CLEANING
1.
Drive the machine on a level fl oor.
2.
Turn the ignition key (80) to "0".
3.
Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16).
4.
Grasp the handle (41) and carefully lift the tank (40).
5.
Check that the pre-fi lter is clean. If necessary clean it with water and compressed air, then install it.
6.
Perform steps 1, 2, 3 and 4 in the reverse order.
SOLUTION/CLEAN WATER FILTER CLEANING
1.
Drive the machine on a level fl oor.
2.
Turn the ignition key (80) to "0".
3.
Close the solution tap (A, Fig. 8) under the machine, behind the left rear wheel.
The tap (A) is closed when it is in the position (B) and it is open when it is in the position (C).
4.
Remove the transparent cover (D) and the gasket (E), then remove the fi lter strainer (F). Clean and install them on the support
(G).
NOTE
Install the gasket (E) and the fi lter strainer (F) properly on the cover (D) and on the support (G).
5.
Open the tap (A) by turning it to position (C).
BA 651 - BA 751 - BA 851 - BA 751C
G
F
E
D
Figure 8
9097293000(3)2010-03 A
USER MANUAL
C
A
B
ENGLISH
P100180
27