Vacuum System Motor Filter Cleaning; Solution Filter Cleaning - Nilfisk SCRUBTEC R 466 Instructions D'utilisation

ENGLISH

VACUUM SYSTEM MOTOR FILTER CLEANING

1. Drive the machine on a level floor.
2. Turn the ignition key (58) to "0".
3. Open the cover (20) and check that the recovery tank (19) is empty, otherwise empty it with the drain hose (24).
4. Close the cover (20).
5. Carefully lift the tank assembly (44).
6. Check that the filter (37) is clean. If necessary clean it with water and compressed air, then install it.

SOLUTION FILTER CLEANING

1. Drive the machine on a level floor.
2. Turn the ignition key (58) to "0".
3. Close the solution tap (A, Fig. 10) under the machine, behind the right rear wheel. The tap (A) is closed when it is in the
position (B) and it is open when it is in the position (C).
4. Remove the transparent cover (D) and the gasket (E), then remove the filter strainer (F). Clean them with water and install
them on the support (G).
NOTE
The filter strainer (F) must be correctly positioned on the housing (H) of the transparent cover (D).
5. Open the tap (A).
C
A
26
USER MANUAL
B
SCRUBTEC R 466 - R 471 - R 471C - BOOST
G
F
E
D
Figure 10
R4
®
H
P100444
9098960000(2)04/2016 A