Nilfisk SCRUBTEC R 466 Instructions D'utilisation page 75

Battery type setting
Set the electronic board of the machine and the battery charger according to the type of batteries installed (WET or GEL/AGM) as
shown below:
5. Turn the ignition key (58) to "I" and, in the very first seconds of machine operation, detect the current setting by counting the
number of flashes of the battery warning lights (62), as shown in the following table:
SETTING DISPLAY (71)
1
2
3
4
5
6
6. If the setting is to be changed, perform the following procedure.
7. Turn off the machine by turning the ignition key (58) to "0".
8. Press and hold the switches (63) and (65) at the same time, then turn the ignition key (58) to "I".
9. Release the switches (63) and (65) at least 5 seconds after starting the machine.
10. Within 3 seconds, shortly press the switch (65) to go to the next setting (1 to 6 in cyclic sequence).
NOTE
When performing steps 9 and 10, the settings are shown on the display (71) too, by the code in the table.
NOTE
When using batteries with a capacity lower than 160Ah@5h (in case of doubt, refer to the battery documents), to avoid
battery overheating during charging procedure, use the REDUCED charging current with setting 4, 5 or 6 shown in the
table, according to the type of batteries installed.
NOTE
The battery charger must be set according to the type of batteries.
Battery charging
11. Charge the batteries (see the procedure in Maintenance chapter).
9098960000(2)04/2016 A
BATTERY WARNING LIGHT INDICATION
(62)
4 flashes of the red warning light
4 flashes of the green warning light
4 flashes of the yellow warning light
2 flashes of the red warning light
2 flashes of the green warning light
2 flashes of the yellow warning light
SCRUBTEC R 466 - R 471 - R 471C - BOOST
USER MANUAL
BATTERY TYPE CHARGING CURRENT
WET
GEL-AGM STANDARD
GEL EXIDE type
®
WET
GEL-AGM REDUCED (see note)
GEL EXIDE type
®
R4
®
ENGLISH
13