Maintenance; Scheduled Maintenance Table; Machine Working Hour Check - Nilfisk Scrubtec R 466 Instructions D'utilisation

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
Squeegee cleaning
Brush/pad cleaning
Tank, debris collection grid and vacuum grid with float cleaning, and
cover gasket check
Chemical Mixing System cleaning and draining (optional)
Squeegee blade check and replacement
Side skirt check (only for SCRUBTEC R 471C)
Solution filter cleaning
Vacuum system motor filter cleaning
Battery (WET) fluid level check
Cleaning the external dust around each motors
Check and adjustment of driving belts between motors and cylindrical
brushes (only for SCRUBTEC R 471C)
Electromagnetic brake efficiency check
Motors ventilation openings check and cleaning
Brush/pad-holder motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
(1) This maintenance procedure must be performed by Nilfisk authorised Service Center.

MACHINE WORKING HOUR CHECK

1. Insert the ignition key (58) and turn it to "I".
2. In the first 2 seconds of machine operation, the display (71) shows the total number of working hours (scrubbing/drying)
performed by the machine.
Turn the ignition key (58) to "0".
22
USER MANUAL
SCRUBTEC R 466 - R 471 - R 471C - BOOST
Daily, after
using the Weekly
machine
R4
®
Every six
Yearly
months
(1)
(1)
(1)
(1)
(1)
(1)
9098960000(2)04/2016 A