Squeegee Installation - Nilfisk SCRUBTEC R 466 Instructions D'utilisation

ENGLISH
Available cylindrical brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Pad installation/removal (for SCRUBTEC BOOST
The machine with BOOST
®
1. Insert the ignition key (58) and turn it to "I".
WARNING!
Before turning on the switch (63), always check that between the deck (5) and the machine there is no foreign
material which may prevent the deck from lifting.
2. Lift the deck by pressing the switch (63).
3. Turn the ignition key (58) to "0" and remove it.
4. Install the pad (A, Fig. 3) so that it engages the plates on the BOOST
5. To remove the pads perform steps 1 to 3, then manually release the pad from the deck plate.

Squeegee installation

1. Install the squeegee (30) and fasten it with the handwheels (34), then connect the vacuum hose (31) to the squeegee.
2. With the handwheel (35), adjust the squeegee so that the rear blades (18) - in all its length - touches the floor and the front
blade is slightly detached from the floor.
16
USER MANUAL
MAGNA GRIT 46 DYNA GRIT 80
deck can be equipped with pads according to the type of floor to be cleaned.
SCRUBTEC R 466 - R 471 - R 471C - BOOST
MIDLITE GRIT 180
R4)
®
deck.
®
Figure 3
®
PROLENE PROLITE
R4 9098960000(2)04/2016 A
UNION MIX
P100437