Machine Long Inactivity; First Period Of Use; Maintenance; Scheduled Maintenance Table - Nilfisk ECOFLEX BA 651 Manuel D'utilisation

ENGLISH

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After using the machine paragraph.
2. Disconnect the battery connector (12).

FIRST PERIOD OF USE

After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for
integrity and leakage.

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
Squeegee cleaning
Brush/pad cleaning
Recovery tank and debris tray cleaning, and cover gasket check
EcoFlex™ system cleaning and draining (optional)
Squeegee blade check and replacement
Solution fi lter cleaning
Vacuum system motor fi lter cleaning
Battery (WET) fl uid level check
Screw and nut tightening check
Check and adjustment of driving belts between motors and
cylindrical brushes (only for BA 751C)
Brush/pad-holder motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
(1) And after the fi rst 8 working hours.
(2) This maintenance procedure must be performed by an authorised Nilfi sk Service Center.

MACHINE WORKING HOUR CHECK

(Only if the machine is equipped with hour counter)
1. Turn the ignition key (80) to "I".
2. Press the switch (73) and read on the hour counter (79) the total number of working hours (scrubbing/drying) performed by the
machine.
3. Press the switch (73) again.
4. Turn the ignition key (80) to "0".
22
USER MANUAL
9097293000(3)2010-03 A
Daily, after using
Weekly
the machine
BA 651 - BA 751 - BA 851 - BA 751C
Every six
Yearly
months
(1)
(2)
(2)
(2)
(2)