Brush/Pad-Holder/Cylindrical Brush Deck Disassembly/Assembly - Nilfisk ECOFLEX BA 651 Manuel D'utilisation

ENGLISH

BRUSH/PAD-HOLDER/CYLINDRICAL BRUSH DECK DISASSEMBLY/ASSEMBLY

The machine can be equipped with either the brush/pad-holder deck (18) or the cylindrical brush deck (19).
NOTE
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the
same width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph.
Disassembly
1. Drive the machine on a level fl oor.
2. Remove the brushes/pad-holders according to the procedure shown in the relevant paragraph. Do not remove the cylindrical
brushes.
3. Turn the ignition key (80) to "I".
4. Lower the brush/pad-holder deck by pressing the switch (71).
5. Turn the ignition key (80) to "0".
6. Remove the safety pins (A, Fig. 7) and [for brush/pad-holder deck (18) only] the mounting pin (B).
7. Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16). Close the
cover (22).
8. Grasp the handle (41) and carefully lift the tank (40) to reach the deck electrical connection.
9. Disconnect the red connector (C) and (for cylindrical brush deck only) the white connector (D).
10. Disconnect the solution hose union (E).
11. Unscrew the mounting handwheel (F), then remove the brush/pad-holder deck (G).
Assembly
12. Assemble the components in the reverse order of disassembly, and note the following:
• When the cylindrical brush deck (19) is installed, the white connector (D) must be connected.
• When the brush/pad-holder deck (18) is installed, fasten the lever with the pin (B).
B
26
USER MANUAL
E A F
9097293000(3)2010-03 A
A G
Figure 7
BA 651 - BA 751 - BA 851 - BA 751C
C D
P100181