Use; Before Machine Start-Up; Brush Or Pad-Holder Installation - Nilfisk Advance Micromatic 13E Instructions D'utilisation

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

14
9

Brush or pad-holder installation

NOTE
The machine is supplied with two brushes (A, Fig. 3) installed. According to the type of fl oor to be cleaned, it is possible
to replace the brushes (A) with the pad-holders with pads (B).
1. Lift the machine by prying the handlebar (2).
2. Install the brushes (A, Fig. 3), or the pad-holders with pads (B), in the 2 hubs of the deck (9).
3. Lower the machine by using the handlebar (2).
A
10
INSTRUCTIONS FOR USE
18
A
9097508000(2)2009-05
3
9
B
Figure 3
MICROMATIC 13E
2
P100166A
B
P100168