Maintenance; Scheduled Maintenance Table; Integrity Check Of Power Supply Cable And Extension; Brush Cleaning - Nilfisk Advance Micromatic 13E Instructions D'utilisation

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the power supply cable
disconnected from the electrical mains.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorized Service
Center.
This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure

Brush cleaning

Squeegee cleaning

Tank and vacuum grid cleaning

Squeegee blade check and replacement
Solution hose fi lter cleaning
Screw and nut tightening check
Vacuum system motor carbon brush check and replacement
(1) And after the fi rst 8 working hours.
(2) This maintenance procedure must be performed by a Advance authorized Service Center.

INTEGRITY CHECK OF POWER SUPPLY CABLE AND EXTENSION

Carefully check if the power supply cable, the extension and the plugs are worn or damaged.
If necessary, have them replaced by the Service Center.
INSTRUCTIONS FOR USE
MICROMATIC 13E
Daily, after using
Weekly
the machine
9097508000(2)2009-05
ENGLISH
Every six
Yearly
months
(1)
(2)
15