Troubleshooting; Scrapping - Nilfisk Advance Micromatic 13E Instructions D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The motors do not turn on.
Dirty water vacuuming is insuffi cient or there is no
vacuuming.
The solution fl ow is insuffi cient.
The brushes do not turn.
The squeegee leaves marks on the fl oor.
The fl oor is wet with dirty water.
(*) This maintenance procedure must be performed by a Advance authorized Service Center.
For further information refer to the Service Manual, available at any Advance Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Brushes
– Pads
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
18
INSTRUCTIONS FOR USE
The power supply cable is faulty or
disconnected from the electrical mains.
The vacuum grid is clogged.
The vacuum hose is disconnected from the
deck or it is damaged.
The squeegees are dirty or the squeegee
blades are worn or damaged.
The gasket of the transparent cover is
damaged.
The vacuum system motor is faulty.
The solution fi lter is dirty.
The driving belt is loose or torn.
The brush motor is faulty.
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The recovery tank is full and the excess of
dirty water is ejected.
9097508000(2)2009-05
Possible Cause
MICROMATIC 13E
Remedy
Replace the cable or connect it.
Clean.
Connect or replace.
Clean or replace the squeegees.
Check and/or clean the seating surface or
replace the gasket.
Replace (*).
Clean or replace.
Adjust or replace (*).
Replace (*).
Remove the debris.
Replace the blades.
Empty the tank.