Before Machine Start-Up - Nilfisk SC400 Mode D'emploi

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Use either the brush (54) or the pad-holder (55 and 56) according to the type of floor to be cleaned.
1. Insert the positioning pin (24) and disengage the machine parking device (23b).
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Place the brush (54) or the pad-holder (55 and 56) under the deck.
4. Lower the deck (10) by using the handlebar (2).
5. Turn the knob (62) to program (63).
6. Press the enabling push-button (69) together with the brush levers (70) to engage the brush/pad-holder to the deck drive hub
(10). If necessary, repeat the procedure until the brush/pad-holder is engaged.
Available brushes and their relevant application guides (suggestions only)
Models
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
Squeegee installation
7. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank filling
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
WARNING!
When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle floor cleaning detergents, wear suitable gloves and protections.
8. Use the filler neck (45) or the removable filler hose (47) to fill the tank (31) with a solution suitable for the work to be performed.
Do not fill the solution tank completely, leave few inches from the edge. Always follow the dilution instructions on the label of
the chemical product used to prepare the solution. The solution temperature must not exceed 40 °C.
Adjustments
9. Adjust the handlebar (2) with the lever (71) to reach a comfortable position.
USER MANUAL
MIDLITE GRIT 180 MIDGRIT 240
9099612000 - SC400
ENGLISH
PROLITE UNION MIX
13