Battery Installation And Battery Type Setting (Wet Or Gel); Before Start-Up; Squeegee Installation - Nilfisk SCRUBBER-DRYER BA 430S Manuel D'emploi Et D'entretien

BATTERY INSTALLATION AND BATTERY
TYPE SETTING (WET OR GEL)
According to the chosen battery type (lead or gel) perform
the setting of the machine electronic board and the battery
charger (if installed on the machine), operating as follows:
Machine setting
1. Ensure that the Battery connector (25, Fig. C) is
disconnected.
2. Remove the key (24, Fig. C) from its housing and
remove the tank assembly fastening screw (1, Fig.
H).
3. Carefully lift the tank assembly (19, Fig. H) using the
handlebar (2, Fig. C).
4. The factory machine setting is for lead (WET)
batteries. If the setting corresponds to the chosen
battery, go to step 8, otherwise perform the
operations described at points 5, 6, 7.
5. Unscrew the screws (4, Fig. G) and carefully remove
the electric component box cover (5) making it slide
upwards.
6. Move the micro-switch (6, Fig. G) upwards
(dip-switch) to GEL position.
WARNING!
Do not move the adjacent switch (7, Fig. G).
7. Reinstall the electric component box cover (5, Fig. G)
and screw the screws (4).
Battery charger setting
8. Take the battery charger selector (18, Fig. H) to WET
position for lead battery, or to GEL position for gel
battery.
Battery installation and charge
9. Install the batteries on the machine according to the
diagram (15, Fig. H).
10. Proceed to the battery recharge (see the procedure in
the Maintenance chapter).
08812942(3)2004-05 A
USE AND MAINTENANCE MANUAL

BEFORE START-UP

Brush or disk-holder installation
NOTE
Depending on the type of floor, either a
brush (24, Fig. H) or a disk-holder (25) with
disk (26) can be installed.
To simplify, the following instructions refer
to the brush only.
1. Lift the brush-holder (9, Fig. C) using the pedal (20,
Fig. C).
2. Position the brush (24, Fig. H) under the
brush-holder.
3. Lower the brush-holder (9, Fig. C) using the pedal
(20, Fig. C).
4. BA 430S D / BA 510S D versions only: turn the key
(9, Fig. B) to "I" position.
5. Press the brush push-button for a few seconds (5,
Fig. B) to hook the brush/disk-holder.

Squeegee installation

6. Install the squeegee into place (10, Fig. C) and fix the
knobs (11), then connect the hose (26) to the
squeegee.
7. Adjust using the knob (12, Fig. C) the squeegee so
that its rear blade (14, Fig. C) - in all its length -
touches the floor and that the front blade (13) is
slightly detached from the floor.
Adjustments
8. Adjust the handlebar (2, Fig. C) using the handles (5),
to reach a comfortable position.
Solution tank filling up
9. Open the cover (2, Fig. H) of the tanks.
10. Fill the detergent tank (6, Fig. H) with an appropriate
solution, depending on the cleaning to be carried out.
It is possible to check the tank filling up using the
marks (27, Fig. C).
Do not fill the solution tank completely and let the
solution level a few centimetres from the rim.
Always follow the dilution instructions on container
label of the chemical product used to create the
solution.
The solution temperature must be under 100°F
(40°C).
CAUTION!
Use only low-foam and non-flammable
solutions, appropriate to the use.
9