Publicité
Les langues disponibles
Les langues disponibles
USE AND MAINTENANCE MANUAL
INTRODUCTION
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the Customer
with all necessary information to use the machine properly
in a safe and autonomous way. This includes information
about Technical characteristics, Operation, Machine
inactivity, Maintenance, Spare parts and Safety
conditions.
Before carrying out any procedure on the machine, the
Operators and Qualified technicians must read this
manual carefully. Contact the Manufacturer in case of
doubts regarding the interpretation of the instructions and
for any further information.
TARGET
This manual is intended for the Operator and the
Technicians qualified for the machine maintenance.
HOW TO KEEP THIS MANUAL
The Use and Maintenance Manual must be kept near the
machine, inside an adequate case, far from liquids and
other substances that can cause damage to it.
CONFORMITY CERTIFICATE
Fig. A shows the documentation certifying the
scrubber-dryer accordance to the Law in force in the
European Economic Community.
IDENTIFICATION DATA
The Machine Model and Serial Number are marked on the
plate on the tank and can be read from the outside (1, Fig.
C).
The machine model year is written in the EC statement
and it is also indicated by the first two figures of the
machine serial number.
This information is useful when ordering machine and
engine spare parts. Use the following table to write down
the machine identification data for any further reference.
MACHINE model .........................................................
MACHINE serial number .............................................
2
OTHER REFERENCE MANUALS
–
Electronic Battery Charger Manual (if installed on the
machine) which is to be considered an integral part of
this manual.
–
Moreover, the following manuals are available:
•
Service Manual (that can be consulted at any
Nilfisk-Advance Service Centre);
•
Spare Part List (supplied with the machine).
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair
procedures must be carried out by qualified personnel or
by Nilfisk-Advance Service Centres (listed at the end of
this manual). Only original spare parts and accessories
must be used.
Call Nilfisk-Advance for service or to order spare parts and
accessories, specifying the machine model and serial
number.
CHANGES AND IMPROVEMENTS
Our Company constantly improves its products and
reserves the right to make changes and improvements at
its discretion without being obliged to apply such benefits
to the machines previously sold.
Any modifications and/or accessory adding must be
approved and performed by the Manufacturer.
SAFETY - ACCIDENT PREVENTION
The following symbols indicate potentially dangerous
situations. Always read carefully this information and take
the necessary precautions to protect people and objects.
The machine Operator's cooperation is essential in order
to prevent injury. No accident prevention program is
effective without the total cooperation of the person
responsible for the machine operation. Most of the
accidents that may occur in a factory, while working or
moving around, are caused by failure to comply with the
simplest rules for exercising prudence. A careful and
prudent Operator is the best guarantee against accidents
and is essential for successful completion of any
prevention program.
08812942(3)2004-05 A
Publicité
Chapitres
Dépannage
