Tank Emptying; After Using The Machine; Machine Long Inactivity; First Period Of Use - Nilfisk SCRUBBER-DRYER BA 430S Manuel D'emploi Et D'entretien

TANK EMPTYING

NOTE
A float automatic closing system (8, Fig. H)
locks the vacuum system once the recovery
tank (5) is full.
The vacuum system locking, caused by the
water tank filling up, is signalled by a
sudden increase in the aspirator motor
noise frequency.
Once the recovery water tank (5, Fig. H) is full, empty it as
follows.
Recovery water tank emptying
1. Stop the machine using the brush and vacuum
push-buttons (5 and 6, Fig. B).
2. Lift the brush/disk-holder using the pedal (20, Fig. C).
3. Lift the squeegee using the lever (19, Fig. C).
4. Push the machine to the appointed disposal area.
5. Empty the recovery tank using the hose (17, Fig. C).
If at the end of the work, rinse the tank with clean
water.
Solution tank emptying
6. Carry out steps from 1 to 4.
7. Empty the solution tank using the hose (18, Fig. C). If
at the end of the work, rinse the tank with clean water.
08812942(3)2004-05 A
USE AND MAINTENANCE MANUAL

AFTER USING THE MACHINE

At the end of the work, before leaving the machine:
1. Disconnect the brush as follows: the brush lifted,
push the brush switch (5, Fig. B) to "I" position; after
a few seconds, put the switch back to off "0" position,
releasing the brush.
2. Empty the tanks (5 and 6, Fig. H), following the
instructions given in the previous paragraph.
3. Perform the maintenance operations after the
machine use (see the Maintenance chapter).
4. Leave the machine in a dry and clean place, with
brush and squeegee lifted or removed.

MACHINE LONG INACTIVITY

If you foresee that the machine will not be used for more
than 30 days, proceed as follows:
1. Perform the operations described in the previous
chapter "After Using the Machine".
2. Disconnect the battery connector (25, Fig. C).
3. If the optional battery charger (16, Fig. H) is installed,
disconnect the positive battery terminal (+) directly
from the battery (+) pole.

FIRST PERIOD OF USE

After the first period of use (first 8 hours) it is necessary to
check that the fixing and connecting elements are
correctly fixed, that the visible parts are integral and that
there are no leakages.
11