Starting And Stopping The Machine; Machine Operation (Washing/Drying) - Nilfisk SCRUBBER-DRYER BA 430S Manuel D'emploi Et D'entretien

USE AND MAINTENANCE MANUAL

STARTING AND STOPPING THE MACHINE

Starting the machine
1. Prepare the machine as described in the previous
paragraph.
2. Lower the squeegee (10, Fig. C) using the lever (19).
3. Lower the brush (8, Fig. C) using the pedal (20).
4. Position the solution flow adjusting lever (7, Fig. B) in
the most appropriate position, depending on the type
of cleaning to be carried out.
5. Keep a hand on the handlebar (2, Fig. C), start the
machine using the brush and vacuum push-buttons
(5 and 6, Fig. B).
NOTE
If the green warning light (2, Fig. B) turns on,
the machine is ready to be used. If the yellow
or red warning lights (3 or 4, Fig. B) turn on,
it is necessary to charge the batteries (see
the procedure in the Maintenance chapter).
Stopping the machine
6. Position the brush and vacuum push-buttons on "0"
(5 and 6, Fig. B).
7. Lift the brush using the pedal (20, Fig. C).
8. Lift the squeegee using the lever (19, Fig. C).
9. BA 430S D / BA 510S D versions only: turn the key
(9, Fig. B) to "0" position.
10
MACHINE OPERATION
(WASHING/DRYING)
1. Start the machine as described in the previous
paragraph.
2. Keep both hands on the handlebar (2, Fig. C),
manoeuvre the machine and start the floor
washing/drying.
BA 430S D / BA 510S D versions only: by pressing the
levers (10, Fig. B), both clockwise than counter-clockwise,
the machine moves forward; rear movement is not
performed.
Traverse speed can be adjusted by turning the adjuster
(11, Fig. B).
To pull the machine backwards or to perform turns with a
very narrow radius, the traverse control has to be
disconnected by releasing the levers (10, Fig. B).
CAUTION!
To avoid damaging to the floor, stop the
brush rotation using the switch (5, Fig. B)
when the machine stops in one place.
CAUTION!
Before lifting the brush/disk-holder, stop its
rotation using the switch (5, Fig. B).
Machine drive controls
3. Depending on the floor type, or on the use of the
brush or the disk-holder, the machine front drive
speed and the forward straightaway movement
(without turning on the right or on the left) can
change.
They can be adjusted using the two knobs (22 and
23, Fig. H) on the brush-holder, proceeding in the
following way:
– The machine moves towards the left by turning
the adjusting knob counter-clockwise (22, Fig. H);
the machine moves towards the right turning the
knob clockwise;
– The machine speed increases by turning the
adjusting knob counter-clockwise (23, Fig. H); the
machine speed decreases turning the knob
clockwise.
08812942(3)2004-05 A