Battery Installation And Battery Type Setting (Wet Or Gel/Agm) - Nilfisk ecoflex BR 652 Manuel D'utilisation

Masquer les pouces Voir aussi pour ecoflex BR 652:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BATTERY INSTALLATION AND BATTERY TYPE SETTING (WET OR GEL/AGM)

Battery installation
1.
Open the cover (20) and check that the recovery tank (19) is empty, otherwise empty it with the drain hose (24).
2.
Close the cover (20).
3.
Carefully lift the tank assembly (44).
4.
Install the batteries and connect them according to the diagram (38).
Battery type setting
Set the electronic board of the machine and the battery charger (optional) according to the type of batteries installed (WET or GEL/
AGM) as shown below:
5.
Turn the ignition key (58) to "I" and, in the very fi rst seconds of machine operation, detect the current setting by counting the
number of fl ashes of the battery warning lights (62), as shown in the following table:
SETTING
DISPLAY (71)
1
2
3
4
5
6
6.
If the setting is to be changed, perform the following procedure.
7.
Turn off the machine by turning the ignition key (58) to "0".
8.
Press and hold the switches (67) and (63) at the same time, then turn the ignition key (58) to "I".
9.
Release the switches (67) and (63) at least 5 seconds after starting the machine.
10.
Within 3 seconds, shortly press the switch (63) to go to the next setting (1 to 6 in cyclic sequence).
NOTE
When performing steps 9 and 10, the settings are shown on the display (71) too, by the code in the table.
NOTE
When using batteries with a capacity lower than 160Ah@5h (in case of doubt, refer to the battery documents), to avoid
battery overheating during charging procedure, use the REDUCED charging current with setting 4, 5 or 6 shown in the
table, according to the type of batteries installed.
NOTE
The battery charger (optional) must be set according to the type of batteries.
Battery charging
11.
Charge the batteries (see the procedure in Maintenance chapter).
BATTERY WARNING LIGHT INDICATION
(62)
4 fl ashes of the red warning light
4 fl ashes of the green warning light
4 fl ashes of the yellow warning light
2 fl ashes of the red warning light
2 fl ashes of the green warning light
2 fl ashes of the yellow warning light
BR 652 - BR 752 - BR 752C
USER MANUAL
BATTERY TYPE
WET
GEL-AGM
GEL EXIDE
®
type
WET
GEL-AGM
®
GEL EXIDE
type
9098684000(2)2010-12 A
ENGLISH
CHARGING CURRENT
STANDARD
REDUCED (see note)
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ecoflex br 752Ecoflex br 752c

Table des Matières